» Bitumen Pressure Distributor
Truck mounted self propelled Bitumen Pressure Distributor with suitable heating system and variable spray bar to operate on constant pressure system, complete with air-compressor, bitumen pump, auxiliary engine, tank mounting and other accessories for uniform and constant rate applications of hot bitumen (or cold tar) as per the specifications indicated below.
||4000 / 5000 / 6000 / 8000 litres.
/ Oval shape with light resin bonded rock wool insulation 50 mm. thick.
Through manhole. ii) Through self-priming by own pump.
type thermometer of range 0° to 250° (minimum).
||4 - Stroke twin cylinder air / water cooled diesel
engine of 25 hp at 2000 RPM.
Block Type 380 to 450 litres per minute.
cylinder 3 HP. Pressure 9 Kg./sq. cm. maximum. Capacity 360 litres.
|Type of Burner
||Single high pressure oil burner for adequate heating
of viscous binder, oil consumption 20 lt/hr.
||Folding type fitted with pressure gauge,
regulating valve etc.
width from 2.4 to 4.2 metres by extension bar.
closing of nozzles.
of spray bar
full circulation of preheated bitumen.
be adjusted between 0-6 bars.
air pressure or diesel oil.
to 1.0 Kg. / sq.m. Calibration chart will be provided inside the
driver's cabin and at the operator's platform.
The operation of the spray bar is from operator's platform at the rear.
TATA 1613 SE Truck Chassis of WB-4225 mm. and 4x2 configuration or equivalent. The driver's cabin will be built as per R.T.O. requirement. The battery used for starting the diesel engine conforms to ISI.
All the bought-out components conform to relevant ISI specifications and are of reputed make.
Trolley mounted in place of Truck mounted.